The Suttner ST-6 is a water-activated flow switch that controls the burner on a hot-water pressure washer - it only kicks on when you start pulling that water behind the gun. So when you pull the trigger, the switch flips and lets the burner start firing - it's a pretty simple process. But as soon as you let go of the trigger and water stops flowing, the switch flips back over and cuts the burner off. This is super important because - as long as a burner is heating up a coil with no water going through it, it just wastes fuel and can cause water to get scalding hot in the bypass line.
The switch itself is pretty tough - it's encased in a hard plastic moulding that keeps the moisture and nasty cleaning chemicals out, so its not too bothered by being submerged in water all day. Theyve also designed it so you can mount the thing however you need to - no need to worry about what direction it's facing. It also gets used a bit in carpet cleaners, but its primary job is sorting out issues with hot water flow on pressure washers.
Key Features:
-
Its got 3/8" MPT threads
-
Its got a 2 wire reed switch with a 47 inch long lead on it
-
Goes from 1 up to 8 GPM
-
Can handle up to 4,380 PSI
-
Max temp is 176°F
-
Mounts in any direction