Pump Made Ready GP TP2530J34 VR54 Unloader Thermal Relief - 6570
Couldn't load pickup availability
High-Performance "Pump Made Ready" TP2530J34 for Fast, Hassle-Free Pressure Washing
The General Pump TP2530J34 Pump Made Ready is a fully plumbed, bolt-on pump assembly designed to get your gas-engine pressure washer running with minimal effort. Built around the General Pump TP2530J34 triplex plunger pump, this made ready configuration arrives pre-assembled with an unloader, inlet and outlet fittings, filter, and thermal relief valve - everything matched and installed at the factory.
Product Details: TP2530J34 Pump Made Ready Assembly
-
Core Pump – General Pump TP2530J34 triplex plunger pump from the 51 Series
-
Performance – 2.88 GPM at a maximum rated pressure of 2500 PSI
-
Shaft & Mounting – Pump shaft size is 3/4 inch; hollow shaft designed for direct mounting to gas engines with SAE J609A-style flanges
-
Operating Speed – Maximum speed of 3400 RPM; power requirement approximately 7.4 GHP
-
Included Components – Pre-installed VRT3 unloader valve, bypass plumbing, thermal relief valve, inlet filter, garden hose inlet fitting, quick connect outlet, and initial fill of non-detergent pump oil
-
Construction – The TP2530J34 features forged brass manifold and ceramic plungers for durability, with stainless steel valves and continuously lubricated packings
-
Temperature Capability – The maximum fluid temperature for the pump is 165°F; suitable for cold and warm water application
-
Oil Capacity – The crankcase oil capacity is 11 ounces
-
Weight – 12 lbs
Frequently Asked Questions
Will this fit my pressure washer engine? It's designed for gas engines with a 3/4" shaft and SAE J609A-compatible mounting. Verify your shaft size, keyway dimensions, and bolt pattern before ordering. Most common small gas engines in the 9–12 HP range are compatible.
Do I need any extra parts to install it? Most plumbing components are included - inlet fitting, outlet quick connect, unloader, filter, and thermal relief valve. However, engine-side hardware like mounting bolts, keys, and frame-specific mounting plates may need to be sourced depending on your setup.
Can it handle warm water? Yes. The maximum fluid temperature for the pump is 165°F, making it capable of handling warm tap or lightly pre-heated water. It is not intended as a true hot-water boiler-fed pump.
How is this better than replacing just the pump head? The made ready assembly removes guesswork around unloader sizing, bypass routing, and fitting selection. You get a tested, factory-matched system that reduces installation time and the risk of leaks or component mismatch.
Ready to Upgrade Your Pressure Washer?
Stop wrestling with failing pumps, mismatched fittings, and underpowered cleaning. The TP2530J34 Pump Made Ready delivers a fast bolt-on replacement with reliable 2,500 PSI performance and the reduced downtime that comes from a factory-assembled, ready-to-run pump assembly.